4/7/2024 0 Comments 9 pin molex connectorDon't let this happen to you!Ĭrimping new connectors is really pretty easy, but tedious. Booted up the game and wasted a circuit board. A number of years ago I removed a connector to inspect it and then put the connector back on-in the wrong position because someone didn't install the keying plug and I wasn't being cautious. I can't tell you how many times I have run into replacement connector work where someone did not use a keying plug. Those keying plugs are very important, and really cheap, too. I would suggest trying Ed at for these parts.Īs dkpinball points out, be sure to get the keying plugs for whatever connector type you are going to use. IDC type does replace the connectors on the WPC/Stern games that the OP listed above, though I too prefer to use the crimp on type connectors. ![]() PBL does carry the crimp type but on a different page. Just to be completely clear.these are IDC connectors as shown in the link, not crimp type connectors. If you want to crimp the ends on (I prefer doing it that way), get the "trifurcon" pins. Pinball Life carries this, which is nice: Sometimes designers make errors, but because they are consistent everything still works.Most of what you'll find is. ![]() ![]() Trying to figure this out just from specifications and documentation can be impossible.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |